Installing Repetier Host on Linux

This was installed on Crunchbang which is a Debian based Linux.

Here are the commands used during the video:
sudo apt-get update
sudo apt-get upgrade
cd downloads
tar -xzf filename
cd RepetierHost/
./configureFirst.sh
usermod -a -G dialout username
repetierHost

If you have any questions, send us an email to 3dprinterhowto@gmail.com or leave a comment below.

Special thanks to ORNL (www.ornl.gov) and NAMII (www.namii.org) and Kevin McCleod for music from www.incompetech.com

NOTE: We are not affiliated with MakerGear.
————————————————————————————————-
Thingiverse: http://www.thingiverse.com/3DPrinterHowTo

Twitter: http://twitter.com/3DPrinterHowTo

Facebook: http://www.facebook.com/3dprinterhowto
————————————————————————————————-
Video Rating: / 5

0 comments… add one

Leave a Comment